ASTM specifications: A276/A276M, A314, A458, A477, A479/A479M, A564/A564M, A565/A565M, A582/A582M, A638/A638M, A705/A705M, and A831/A831M. 1.2 In the case of conflict between a requirement of a product specification and a requirement of this
1.1 This specification 2 covers bars and shapes of age-hardening stainless steels. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging.
This specification covers age-hardening stainless steel forgings for general use. Materials for forgings shall consist of billets or bars and shall either be forged, rolled, or cast or a section cut from an ingot. The steel specimens shall be solution annealed and age hardened and shall conform to the required values of tensile strength, yield
138.0 mm] round bar. 10 to 12ft [3.0 to 3.6 m] in length, ASTM A 564 dated . End usc: valve shafts. 4. General Requirements 4.1 In addition to the requirements of this specification, all requirements of the current edition of Specifications A 484/ A 484M shall
Designation: A564/A564M − 19aStandard Specif i cation forHot-Rolled and Cold-Finished Age-Hardening Stainless SteelBars and Shapes 1This standard is issued under the f i xed designation A564/A564M; the number immediately following the designation indicates the yearof original adoption or, in the case of revision, the year of …
Designation: A564/A564M − 13Standard Specification forHot-Rolled and Cold-Finished Age-Hardening Stainless SteelBars and Shapes1This standard is issued under the fixed designation A564/A564M; the number immediately following the designation indicates the yearof original adoption or, in the case of revision, the year of last revision.
The speci- 'mens shall be heat treated in accordance with 5.1. Unless otherwise specified in the purchase order, the condition of hhardening heat treatment shall be at the option of the producer and testing shall be done at 70 to 80 °F [20 to 25 °C]. The tests shall meet the requirements of Table 4. When tested at temperatures other than 70