The aim of this study is to investigate the low-cycle fatigue (LCF) properties of an AISI 304L welded joint based on experimental data. The influential parameters on the LCF such as the specimen thickness, strain ratio and cryogenic temperature were considered in this experimental study. In order to investigate the thickness effect on the …
The aim of this study is to investigate the low-cycle fatigue (LCF) properties of an AISI 304L welded joint based on experimental data. The influential parameters on the LCF such as the specimen thickness, strain ratio and cryogenic temperature were considered in this experimental study. In order to investigate the thickness effect on the …
Plasticity-induced martensitic transformation during cyclic deformation of AISI 304L stainless steel Mater. Sci. Eng. A, 114 (Jul. 1989), pp. L11-L16, 10.1016/0921-5093(89)90871-X View PDF View article View in Scopus Google Scholar [16] I. …
Abstract. Specially designed billets of AISI 304L stainless steel were forged at two temperatures, 843 °C and 941 °C, and with varying transfer times. The machined 304L billets were thick near the center (51 mm) and thin near the periphery (10 mm) such that forging with a flat platen resulted in regions of high strain (center) and low strain
Two types of wrought AISI 304 steels, namely AISI 304 or 304L, and a niobium stabilized grade AISI 348 have been studied in the present work. The AISI 304-type steel was delivered in three forms: (i) cold-drawn cylindrical bar of 20 mm in diameter, hot-rolled 6 mm thick plate (1D finish) and cold-rolled 1 mm thick sheet (2B finish); AISI 348 …
FE-SEM micrographs of ASTM A36 and AISI 304L after exposure to solar salt at 390 C for 7, 14, and 21 days. Instead, depth profiles of the chemical composition obtained by GDOES were employed. The results are shown in Fig. 10, where iron and oxygen were displayed for carbon steel.
Table 6 displays the AISI 304L reaction for material removal rate (MRR) within the three levels of each selected input parameter in this study. The highest values of MRR were achieved in abrasive waterjet contour cutting of AISI 304L, with 421.2 mm³/min for 4 mm, 767.10 mm³/min for 8 mm, and 811.4 mm³/min for 12 mm material thicknesses.
Best suited process parameters for welding of AISI 304L and AISI 202 stainless steel of thin plates are current—65 A, welding speed—6 mm/s, CTWD—10 mm and shielding gas—pure argon. This combination of parameter gives the best results for mechanical properties that join the sheets efficiently.