Thread turning requires special attention in order to produce precise threaded parts with low tool wear and high productivity. This is even more critical for components of austenitic stainless steel due to its poor machinability. This paper investigates the influence of the infeed method on thread turning of AISI 304L austenitic …
Impedance modulus at 4 mHz for (a) ASTM A36and (b) AISI 304L after exposure to solar salt at 390 C as a function of time. To obtain more information about the multilayer developed in stainless steel, a novel approach proposed by Benoit et al. [43] was used, which allowed estimating the thickness of oxide films and layers.
The present work investigated the compressive and tensile properties of AISI 304L austenitic stainless steel subjected to equal channel angular pressing (ECAP) at high temperature (700 C). Tensile and compressive strength, elongation, Vickers hardness and fracture mode of annealed and ECAPed material were systematically compared.
AISI 304L, AISI316Ti, and AISI 321 are not designated for mechanical welding blades with square assemblies of 100 × 150, × 0.25 mm (including the blades' edge). Tables 1(a) and 1(b) show the chemical and tensile properties of steel mills made from AISI (321, 316Ti, 316L, and 304L) stainless-state tubes.
AISI 304L stainless steel is an austenitic stainless steel formulated for primary forming into wrought products. 304L is the AISI designation for this material. S30403 is the UNS number. Additionally, the British Standard (BS) designation is 304S12. This material is well established: the Further Reading section below cites a number of …
SAE 304 stainless steel is the most common stainless steel. The steel contains both chromium (between 18% and 20%) and nickel (between 8% and 10.5%) [1] metals as the main non- iron constituents. It is an austenitic stainless steel. It is less electrically and thermally conductive than carbon steel. It is magnetic, but less magnetic than steel.