Designation: A564/A564M − 19Standard Specif i cation forHot-Rolled and Cold-Finished Age-Hardening Stainless SteelBars and Shapes 1This standard is issued under the f i xed designation A564/A564M; the number immediately following the designation indicates the yearof original adoption or, in the case of revision, the year of …
Referenced Documents. 2.1 ASTM Standards: 1.1 This specification covers bars and shapes of age. A 314 Specification for Stainless Steel Billets and Bars for. hardening stainless steels. Hot-finished or cold-finished. Forging. rounds, squares, hexagons, bar shapes, angles, tees, and. A 370 Test Methods and Definitions for Mechanical Test.
ASTM A564 -A564M - 19 : 800 : This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade …
ASTM A564 é uma norma (especificação) de material (aço inoxidável) que define o que ele deve ter ou possuir para poder ser chamado de "A564". Aplicações da ASTM A564 A A564 é geralmente utilizada para barras ou outras peças que requerem resistência a corrosão e alta resistência a temperatura ambiente.
ASTM A564 Specification. This specification2 covers bars and shapes of agehardening stainless steels. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging. Billets or bars for reforging may be purchased to this specification.
1.1 This specification 2 covers bars and shapes of age-hardening stainless steels. Hot-finished or cold-finished rounds, squares, hexagons, bar shapes, angles, tees, and channels are included; these shapes may be produced by hot rolling, extruding, or forging.
138.0 mm] round bar. 10 to 12ft [3.0 to 3.6 m] in length, ASTM A 564 dated . End usc: valve shafts. 4. General Requirements 4.1 In addition to the requirements of this specification, all requirements of the current edition of Specifications A 484/ A 484M shall
The speci- 'mens shall be heat treated in accordance with 5.1. Unless otherwise specified in the purchase order, the condition of hhardening heat treatment shall be at the option of the producer and testing shall be done at 70 to 80 °F [20 to 25 °C]. The tests shall meet the requirements of Table 4. When tested at temperatures other than 70