Designation: A269/A269M − 15 Standard Speci f i cation for Seamless and Welded Austenitic Stainless Steel Tubing for General Service This standard is issued under the fi xed designation A269/A269M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.
Current edition approved March 1, 2008. Published April 2008. Originally approved in 1944. Last previous edition approved in 2007 as A 269 – 07a. 2 For referenced ASTM standards, visit the ASTM website,, or contact ASTM Customer Service at [email protected]. For Annual Book of ASTM Standards volume information, refer to the
Stainless steel seamless tubing of ASTM A269 Gr. TP316L, bright annealed, 12.7 mm (o.d.) x 0.89 mm (w.t.) x 4000 mm (length), supplied to Durban, South Africa. The tubing sizes and thicknesses usually furnished to ASTM A269 are 1/4″ [6.4 mm] in inside diameter and larger and 0.020″ [0.51 mm] in nominal wall thickness and heavier.
Designation: A269/A269M − 15aStandard Specif i cation forSeamless and Welded Austenitic Stainless Steel Tubing forGeneral Service 1This standard is issued under the f i xed designation A269/A269M; the number immediately following the designation indicates the yearof original adoption or, in the case of revision, the year of last revision.
1.2 The tubing sizes and thicknesses usually furnished to this specification are 1 / 4 in. (6.4 mm) in inside diameter and larger and 0.020 in. (0.51 mm) in nominal wall-thickness and heavier. 1.3 Mechanical property requirements do not apply to tubing smaller than 1 / 8 in. (3.2 mm) in inside diameter or 0.015 in. (0.38 mm) in thickness.
1.1 This specification covers grades of nominal-wall-thickness, stainless steel tubing for general corrosion-resisting and low- or high-temperature service, as designated in Table 1. 1.2 The tubing sizes and thicknesses usually furnished to this specification are ¼ in. (6.4 mm) in inside diameter and larger and 0.020 in. (0.51 mm) in …